Customer Helpline
1300 889 028
14
Operating Instructions
6. ADJUSTING THE CUTTING ANGLE (SEE FIG. G, H)
Using a Allen key (4). Loosen the bolts securing the base plate (SEE FIG G). For preset
angles rotate so the lines of the angle on the base plate and angle plate (6) superposition
at the desired angle (0°, 15°, 30°, 45°) (SEE FIG H).For other miter angles, rotate to your
desired angle (use a protractor scale). Following one of the above procedures, hold the base
plate in position and firmly tighten the bolts to clamp the base plate at the desired angle.
Finally, check the angle and ensure the base plate is firmly clamped. The angle markings
on the base plate are accurate for most general purposes but it is recommended for
accurate work to set the angle with a protractor and make a test cut on other material.
7. STARTING OPERATION
1) LOCK OFF SWITCH
The lock off switch (2) is used to prevent unintentional starting. For starting operation of
the tool, first depress the lock-off button (1) and hold it in position, then press the lock off
switch and release the lever to start operation.
For safety reasons the lock off switch of the tool cannot be locked; it must remain pressed
during the entire operation.
2) FINGER PROTECTION
The finger protection is located in front of the blade holder. Whilst working, it will help
prevent accidental contact with moving blade.
4
G
H
