toolport ALULine Economy 3m x 3m, Assembly Instructions Manual

Page: 11 / 48

11
ALU Line Economy 3m x 3m
During the Assembly
Take the item out of its storage bag.
Slightly extend the gazebo by slowly pulling on the opposite corner poles. (Dia.1)
Put the roof on the partly extended frame and make sure that the corners of the
uprights match the corners in the tarpaulin. Also, the centre pole must sit at the centre
spot of the tarpaulin.
(Dia.2)
Now fully extend the frame while adjusting the join ts in each corner on a height
where the locking pins snap in to secure them. (Dia.3)
Note: If there is a lot of resistance, the item is not yet fully extended.
Attention: Fingers may get caught by the joints.
Pull the t elescopic uprights out of the corner poles. To do that simply place your foot on
the base plate of the uprights and pull on the upper part until the pin snaps in. (Dia.4-5)
Note! You can choose between 3 or 5 different height levels.
Bring the roof in its final position. To do this, use the Velcro fasteners in the corners and
the also the ones which are sewn in the inside of the tarpaulin and connect them to the
poles. (Dia.6)
Secure each upright by means of the pegs (3) that were included in the delivery. Simply
drive them through the holes in the foot plates.
(Dia.6)
Attention! Please check that all pegs fit tightly and that the ground is not to soft.
Knot a guy rope with each loop at the outer corners of the roof. Tension the guy ropes
and fix them to the ground with pegs (Dia.8) .
Attention! Please check that all pegs fit tightly and that the ground is not to soft.
Attach the side panels by means of the Velcro straps / plastic hooks attached to the
side panels (Dia.7) .
•
•
•
•
•
•
•
•
•
•
•
•
•
•