Zeus200
User Manual
V 1.0.8
– 12/10/2020
Page 10 of 16
2.2.2 Mode Menu
The following figure shows the menu related to the different modes of system operation.
➢
Mode - Automatic
: this mode operates as follows:
Type
Power on
Filter
Power off
Filter
End of charge
Seal Pb
12,2V
For 3 min 14,2V
or
charge
current <6A
For 3 min
After 5 min
Free acid Pb
12,2V
For 3 min 14,8V
or
charge
current <6A
For 3 min
After 5 min
Lithium
12,8V
For 1 min 14,2V
or
charge
current <3A
For 1 min
After 1 min
In case of 24V batteries turn on and turn off voltages will be doubled
•
Mode
– Manual:
this mode operates as follows:
Power on
:
o
Pressing the icon
in Home Menu
Power off
:
o
Same as automatic mode or pressing
•
Battery - Automatic:
in this case the
priority is given to the charge of the primary
battery (services) with respect to the secondary one (engine). Nevertheless, the latter
is constantly monitored and if its voltage falls below a minimum value it will be
immediately charged
•
Battery
– Engine Battery:
forcing engine battery charging;
to be used only in case
of emergency, when the vehicle battery is too low
. By activating this function all the
energy produced (over 250W) will be sent to the secondary battery (engine) in order to
quickly recharge it. This function is automatically excluded after 6 hours or when the
battery is fully charged. Once the secondary battery has been recharged, the system
automatically switches to the primary battery (services).
Note:
I
n this mode the energy required for ignition and operation is taken from the primary
battery. Before selecting this function, make sure that the primary battery is fully charged.
Back to Settings Menu
Automatic Mode
Manual Mode
Battery
automatic
selecion
Engine
battery
forcing
