19
TROUBULESHOOTING
(CONTINUED)
IMPORTANT!
Be CERTAIN to shut off the Plasma Cutter, and disconnect it from power and air
before adjusting, cleaning, or repairing the unit, A technician should discharge all
capacitors before performing any internal procedures.
CUT GOES ONLY PARTIALLY THROUGH THE WORKPIECE
Material being cut is too thick. Maximum thickness for steel is
10MM
.
WITHIN THICKNESS RANGE
Turn up the current adjustment knob
and try again.
MATERIAL TOO THICK
You may wish to cut the object along one
side and then cut along the other. If this is
not practical, use a more powerful Cutter.
PROBLEM CORRECTED
You may wish to take note of the
setting required for this metal
thickness
PROBLEM PERSISTS AT MAXIMUM
SETTING
The Air pressure may be too low. Check
the Air Pressure setting on the regulator’s
gauge.
AIR PRESSURE CORRECT
Disassemble the torch assembly and
inspect all internal components, as
explained on page 11.
AIR PRESSURE TOO LOW
a. Verify
that
the
compressor
is
delivering at least 3.5 CFM @80 PSI to
the tool.
b. The Regulator on the unit must be set
to at least 60 PSI.
TORCH IN GOOD CONDITION
Try cutting at a slower pace, the arc
may not have enough time to cut
through the work piece.
DAMAGED COMPONENTS FOUND
Replace any damaged or missing
components and reassemble carefully,
Summary of Contents for 597078
Page 1: ...1 ...
Page 16: ...16 ASSEMBLY STRUCTURE ...
Page 18: ...18 Wiring Diagram ...
Page 20: ...20 ...