26
8. Operation
a) Switching on and off
• To switch the device on, slide the on/off switch (2) forward.
• To switch the device off, slide the on/off switch (2) back to its original position.
b) Setting the vibration frequency
• Turn the vibration frequency controller (4) to set the vibration frequency:
The vibration frequency can be set between "1" and "6", where "1"
corresponds to the lowest vibration frequency (11000 min
-1
) and "6"
to the highest vibration frequency (21000 min
-1
).
9. Troubleshooting
The multi-purpose tool does not switch on:
• The battery is depleted. Charge the battery using the corresponding charger.
• The battery is not correctly inserted into the battery compartment on the back of the device.
The device vibrates vigorously and/or is very loud:
• The insertion tool is not attached properly to the tool holder (3). Check that the insertion tool is firmly seated.
Saw cuts are not clean / the edges of the cut are frayed.
• The saw blade is worn out or damaged and must be replaced.
• A saw blade that is unsuitable for the material or saw cut type was used.
• Protect sensitive materials (e.g. coated chipboard) with adhesive tape. The adhesive tape prevents fraying at the
cutting edge. A thin block of wood can also be cut at the same time to prevent fraying at the cutting edge.
Sawing performance is poor:
• The saw blade is worn out and must be replaced.
• The vibration frequency is not set correctly.
