TOOL WAREHOUSE WT03056, Original Instructions Manual

Page: 12 / 15

Slide the battery pack onto the charger.
Connect the charger to a suitable mains socket. The charger may become
warm and buzz slightly during charging. This is normal and does not indicate
a fault.
3. When the charger is plug in ,the green light will light up.
When the battery pack is charging the red light will
blink. When the battery pack is fully charged, the red
light will stop blinking and remain lighted up
4. After charging, unplug the charger from the wall
outlet.
The battery pack can become warm if the machine is subject to heavy
use. Always allow the battery pack to cool down before re-charging.
OVERLOAD PROTECTION AND OTHER SAFETY FEATURES
The machine/battery pack has a number of safety features that prevent
damage to the machine and battery pack during use.

During short high-load situations the overload protection may turn off the
machine/ battery pack. This protection resets automatically. Release the
trigger, wait a few seconds, ensure that there is no load and restart the
machine. The machine should now function normally again.

During high-load for extended periods the overheating protection may turn
off the machine/battery pack. The protection resets itself but the machine
cannot be restarted until it has returned to normal operating temperature.
Let the machine cool properly before trying to restart it. Adverse
temperatures can occur in direct sunlight and should therefore be
avoided.

The battery pack has low-voltage protection which comes into effect when
the batteries becomes discharged. The low-voltage protection turns off
the machine automatically and the battery pack should be recharged.