TONI TMS210F, Owner'S Instruction Manual

Page: 12 / 19

1
2
3
4
Fig. 5
Fig.6
1
5
3
4
2
WORK CLAMP (Fig. 5).
WARNING:
In some operations, the work clamp assembly may interfere with the operation of
the blade guard assembly.
Always make sure there is no interference with the blade guard prior to beginning any cutting
operation to reduce the risk of serious personal injury.
The work clamp is used to hold the long section of the workpiece firmly in place while making a cut.
NOTES:
There is a clamp rod hole in the left rear corner of the base that
may be more convenient for holding some workpieces that are
odd shapes.
1.
Insert the work clamp rod (1) into the clamp rod hole (2)
located in the left rear corner of the base
2. Loosen the cross bar adjusting knob (4) and slide the
cross bar up or down until it is approximately 60 mm
above the base.
3. Tighten the clamp rod lock knob(3).
INSTALLING A NEW BLADE
A blade should be replaced if it is dull, bent or broken.
1.
Turn the mitre saw switch OFF and remove the plug from the power source.
NOTE: Do NOT touch the blade immediately after use. It will be extremely hot. Wait at least five
minutes for the blade to cool.
2.
Raise saw arm.
3. Rotate lower blade guard(1) up as far as it will go.
4. Depress the spindle lock button(2) and rotate the hex bolt(3) until the spindle locks.
5. Using the hexagon key(4) provided, loosen and remove the hex bolt(3).
NOTE:
The hex bolt has left hand threads. Turn hex bolt clockwise to loosen.
6. Remove the outer blade flange(5). Do not remove the inner blade flange.
7. Fit saw blade inside lower blade guard and onto spindle. The blade teeth point downward at the
front of saw as shown in figure
6 .
!
ASSEMBLY AND INSTALLATION
12