TonerRefillKits.com
RechargX™ RX180 v2
Mon - Fri 8am - 5pm ET
© 1995-2012 ReChargX™, EmptyX, TonerRefillKits and TonerRefillKits.com, the TonerRefillKits logo, the
2012.02.21
800.527.3712 or 352.343.7533 ReChargX™ and EmptyX logos are trademarks owned by TonerRefillkits, LLC. All rights reserved.
Page 3 of 10
Step 5: Plug in the Hole-Making Tool
Plug in the hole-making tool included with the
ReChargX™ Tool Kit.
Turn the sand timer over and wait the full three
minutes before using the tool so it reaches
proper operating temperature; this ensures the
tool will easily penetrate the cartridge housing
(figure 6).
Step 6: Create the Toner Hopper Hole
Hold the ReChargX hole-making tool directly over
the location for the hole and press the copper
hole-making bit against the cartridge allowing
the heat of the tool to create the toner hopper
hole.
MLT-D105S: Please refer to figure 7a.
MLT-D105L: Please refer to figure 7b.
Let the tool do the work with a minimal amount
of pressure (figure 7a or 7b).
Note:
Once the copper tip of the hole-making
tool slowly penetrates the top of the toner
cartridge, immediately withdraw the tool and
unplug it from the wall.
Step 7: Remove the Excess Plastic From
the Hole-Making Tool
Use the metal tip of the small flat-blade
screwdriver, included in the ReChargX™ Tool
Kit, to remove the small, circular piece of
plastic that will normally remain inside the
copper hole-making bit (figure 8).
NOTE:
This step needs to be completed before
the hole-making tool cools off. If the plastic
does harden inside the copper bit, plug in the
tool and remove the plastic debris as soon as it
starts to loosen from the bit.
Figure 6
: Waiting for the hole-making tool to heat up
Figure 7a
: Creating the MLT-D105S toner hopper hole
Figure 7b
: Creating the MLT-D105L toner hopper hole
Figure 9
: Removing the excess plastic piece
