- 18 -
4. Before Use
■ Preparation of the wrench and procedures of torque setting are shown in the
following.
WARNING
●
Check followings before connecting plug into power source.
Failure to follow these instructions may result in serious injury due to
accidental starting.
4.1 Check for any deformation, crack or damage on wrench body, reaction plate,
electric cord, electric plug, socket, o-ring, pin and etc. before use.
Do not use wrench if any problem is found on items listed above.
Make sure that HSH set screws for reaction plate are securely fastened.
Refer
“
Changing Accessories
”
on page 19.
4.2 Make sure to use adequate power supply and batteries.
Use adequate power source and batteries as indicated on the rating plate.
4.3 Make sure to use adequate socket/pin/o-ring suitable for bolt/nut to be
tightened.
4.4 Impact socket should be securely installed on the wrench with pin and o-ring.
4.5 Correct insertion of microSD memory card is needed to store measured torque
values in the microSD card and to review them on the computer.
