Console #1
·
Press the MAINT key to enter Maintenance Mode.
·
Select SETUP.
The Setup menu will be displayed.
·
Select LOOPS from the Setup menu.
Current loop settings will be displayed.
·
Program call appearances 1 through 10 and 13 as Terminate (T), 11 and 12 as Originate (O), and 14
through 22 as Unused (blank).
Console #2
·
Press the MAINT key to enter Maintenance Mode.
·
Select SETUP.
The Setup menu will be displayed.
·
Select LOOPS from the Setup menu.
Current loop settings will be displayed.
·
Program call appearances 1 through 10 as Terminate (T), 11 as Non-reserved (N), 12 and 13 as
Originate (O), and 14 through 22 as Unused (blank).
NOTE
– When the ORIGINATE button on the 40d or a DSS button on the 120d is pressed, the 40d
searches for an idle call appearance using the following order: 1) call appearances
programmed as Originate (O) in descending order, then 2) call appearances programmed as
Non-reserved (N) in descending order, and finally 3) call appearances programmed as
Priority (P) in descending order. Call appearances programmed as Terminate (T) or Unused
(blank) are never selected.
IMPORTANT
– Each call appearance that is programmed at the 40d to be searched must also be
programmed in network translations as: not reserved, reserved for origination,
reserved for priority calls and origination. If a selected call appearance at the 40d is
not matched by a capable or existing call appearance at the network, any request by
the 40d for a call origination on this call appearance will be ignored by the network.
Main and Backup
Inbound calls to the LDN alert at the main attendant’s console. These calls will only alert at the backup
attendant’s console after a predetermined ring delay period. The backup attendant can cancel delayed
ringing at any time. Inbound calls to the backup attendant’s PDN are unaffected when delayed ringing is
invoked.
In this example two 40d consoles will be sharing ten call appearances. The main attendant will be
operating console #1, and the backup attendant will operate console #2.
Network Programming Issues
Set up console #1 and console #2 in the same manner as in the Shared Call Appearances section above.
Page 74
13-102633 Rev. H
Tone Commander 40d120 Installation Instructions
Summary of Contents for 40d120
Page 118: ...Page 118 13 102633 Rev H Tone Commander 40d120 Installation Instructions...
Page 126: ...Page 126 13 102633 Rev H Tone Commander 40d120 Installation Instructions...
Page 132: ...Page 132 13 102633 Rev H Tone Commander 40d120 Installation Instructions...
Page 142: ...Page 142 13 102633 Rev H Tone Commander 40d120 Installation Instructions...
