Tomy SX-300E, Operator'S Manual

Page: 52 / 60

ー 51 ー
9. WHEN A MALFUNCTION IS SUSPECTED
When the autoclave does not operate normally even though operation is carried out according
to the operation manual, carry out checking by referring to “Problems and countermeasures”.
When a problem is not in accordance with the items or its countermeasures seem to be difficult,
unplug the power plug of the autoclave from the outlet and contact the dealer or business
institution of our company.
9-1. Problems and countermeasures
Problem Cause Countermeasures
Nothing is displayed on the
control panel although the
power supply switch is turned
ON.
The power cable is not connected. Check the power cable for connection.
The fuse or breaker at the power
supply side is blown or tripped.
Connect the power cable to the power
supply with the power capacity
required for the autoclave.
The temperature rises slowly. The volume of water in the chamber
is extremely large.
The volume of articles to be sterilized
is large.
Check the volume of sterilizing water
and optimize the volume.
Optimize the volume of articles to be
sterilized.
Sterilization is not carried out
sufficiently.
The sterilizing time is insufficient. Extend the sterilizing time.
Steam leaks from the chamber
lid.
Dusts etc. are adhering to the chamber
lid gasket or opening of the chamber.
The chamber lid gasket is damaged
or broken.
Clean the chamber lid gasket or
opening of the chamber.
Unplug the power plug of this
instrument from the outlet and contact
us or our dealer/distributor from
which you purchased this instrument
for repair service.
Steam leaks from the safety
valve.
The pressure in the chamber is high. Unplug the power plug of the
autoclave from the outlet and contact
the dealer or business institution of
our company.
An error code is displayed and
operation does not start or is
interrupted.
Take countermeasures corresponding to the relevant error code referring to the
error code table.