6
Set reminder types: ring, vibration, ring and vibration, vibrate after ringing, mute
Select ringtone
Select the notification tone
10.7 Action
Incoming call flipping mute: When it is turned on, the watch will be muted when there is an
incoming call flipping
Alarm clock rollover and mute: When it is turned on, the alarm clock is time to rollover the
watch to mute
Gesture wake-up system: when it is turned on, tilt the watch to turn off the screen, lay the
watch flat, and the screen will light up 90 degrees toward you
Shake to answer a call: When it is turned on, the caller interface shakes the watch two or
three times to answer the call
10.8 Restore factory settings
Click on the watch to restore factory settings
→
After the watch automatically restarts, all data
from the previous operation of the watch will be cleared and it will be restored to the initial state.
10.9 About
Can check the watch Bluetooth name, device address, Bluetooth address, and watch software
version number
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used
in portable exposure condition without restriction.
