- 23 -
- 24 -
If your V2 is unbalanced, vibrating, or not turning properly, you can follow the below steps to calibrate it.
·In order to the balance calibration system work properly, please place the scooter on a flat horizontal
surface.
·Press and hold the ON/OFF button for at least 5 seconds until the scooter buzzes.
·The LED light on the deck will begin flashing red.
·The red LED light on the deck will first start blinking and later stay on for a few seconds more, after that
lights will turn off automatically, at this point please press the ON/OFF button to completely switch off the
scooter.
·Press the ON/OFF button the switch the scooter on again. At this point the calibration process will be
complete.
While riding your V2 Scooter, if there is a system error or illegal operation performed with your device, the
system cannot enter self-balancing mode, so the device will prompt the user in a variety of ways.
You will notice the Running Indicator Light will turn RED and you will hear a beep sound alerting you to take
precaution and cease operation.
The following are common occurrences where you will hear the Safety Alerts. These notices should not be
ignored, but appropriate action should be taken to correct any illegal operation, failure or errors.
·Prohibited riding surfaces (uneven, too steep, unsafe, etc.)
·When you step on the device, if the platform is tilted more than 10 degrees forward or
backward.
·Battery voltage is too low.
·The device is still charging.
·During operation, the platform self-initiates to tilt due to excess speed.
·Overheating, or motor temperature is too high.
·The device has been rocking back and forth over 30 seconds.
·System enters protection mode, the alarm indicator will light up and buzzer will alarm
(this typically occurs when the battery is about to run out of power).
·If the platform is tilted forward or backward more than 15 degrees, device will power
off.
·If any or both tires are blocked, the device will stop after 2 seconds.
·When the battery level has depleted below protection mode, the device engine will
power off after 15 seconds.
· While sustaining a high discharge current during use (such as driving up a steep slope
for a long period of time), the device engine will power off after 15 seconds.
PRODUCT WARNINGS
Chapter 4
3-4.BALANCE & CALIBRATION