FAN MOTOR
BLUE WIRE
LIGHT KIT
BLACK WIRE
FAN MOTOR
WHITE WIRE
LIGHT KIT
ASSEMBLY
LIGHT KIT
WHITE WIRE
MOTOR LIGHT
KIT FLANGE
CONNECTOR
(2)
Figure 16
LIGHT KIT
ASSEMBLY
MOTOR
HOUSING
SCREWS (3)
NOTE: Make sure all wires and
connectors are tucked under the light kit
assembly and not pinched between light
kit assembly and motor light kit flange.
2.
Remove and retain one of the three pan
head screw/lockwashers from the motor
light kit flange (Figure 17); loosen the other
two pan head screws three or four turns.
Position the light kit assembly on the motor
light kit flange so that the two screws mate
with the two keyhole slots in the light kit
assembly (Figure 17).
3.
Turn the light kit assembly clockwise and
tighten both screws (Figure 17). Reinstall
the other pan head screw/lockwasher in
the remaining hole in the light kit assembly.
1.
Connect the black wire connector of the
light kit assembly to the blue wire
connector of the fan motor assembly.
Connect the white wire connector of the
light kit assembly to the white wire
connector of the fan motor assembly
(Figure 16).
Figure 17
LIGHT KIT
TIP (3)
SOCKETS (3)
GLASS
FLAT AREA OF
GLASS (3)
LIGHT
BULBS (3)
Figure 18
4.
Install three 60-watt (maximum) candelabra
base light bulbs (not supplied) into the light
light sockets (Figure 18).
5.
Place the glass into the opening in the light
kit assembly, aligning the three flat areas on
the top edge of the glass with the three light
kit tips on the light kit assembly and turn
the glass bowl clockwise until it stops
(Figure 18).
NOTE: periodically check that the glass
is seated fully clockwise in the light kit
assembly.
12
How to Assemble
Your Downlight
BP7389 Prado TB310 2/1/09 2:29 PM Page 12
