11. Transmitter Battery Installation and Code Setting
(Continued)
30
Tommy Bahama • 04/2013
[email protected] • 1-800-875-3545
11.4
r
12e
12a
B
a
tt
e
ry
INSTALLATION OF THE BATTERY
Reach inside the battery compartment and gently extend the
battery connector harness r outside the compartment for
connection with the 9-volt battery 12e .
11.3
SETTING THE OPERATING FREQUENCY OF THE
HANDHELD REMOTE CONTROL TRANSMITTER
Your remote control transmitter 12a has code switches
which must be set in one of 16 possible code combinations.
The four levers (numbered 1, 2, 3, and 4) on the switches
are factory-set in the ON (up) position. Do not use this
setting. Change the switch settings as follows:
Slide the first four switch levers in the transmitter 12a to
your choice of ON (up) or OFF (down) positions. Use a
ball-point pen or small screwdriver to slide the levers
firmly up or down.
The fifth switch labeled “X” controls the light dimming of
the remote control. Setting the switch to the "D" position
allows the controls to dim the light kit from a low setting
up to full intensity. Disable the dimming feature by setting
the cose switch to the "X" position.
NOTE: Non-dimming fluorescent lamps will flicker
when using the dimming feature. Your fan is supplied
with non-dimming fluorescent lamps. Set the dimming
switch to the "X" position to turn the dimming feature
off.
TRANSMITTER CODE
SWITCHES 1, 2, 3, AND 4
ON
1
2
3
4
ON
X
D
DIMMING
ON
DIMMING
OFF
12a
