Tomahawk TG3500i, Operation Manual

Page: 17 / 44

Overload indicator
When the over/oad indicator lights up and the generator
senses that the output of the connected electrical equipment has
been overloaded
,
resulting in overheating of the frequency
converter or an increase in the AC voltage. At this point, AC
protector work
,
stop the generator power generation to protect
the generator and connected electrical equipment· The AC
indiqator(green)goes off,th_e overload indicator(red)lights, but the
engme does norstop runnmg.
Wnen the overload indicator light is on and the generator is not
in use take the following response:
1. Turn off the connected electrical equipment and stop the
engme.
2. Reduce the total power of the connected electrical
equipment to within the rated output range.
3
.
Check if the air inlet is blocke
d or
the control parts are
abnormal
4
·
After checking
,
restart the engine
.
Attention: Whe n u sing
electrical equipment with
higher starting current
(such as a compressor,
submersible pump, etc
· ) ,
the overload indicator light
may turn on for a few seconds.
AC indicator (green)
13