tomado TWM8001W, Instruction Manual

Page: 45 / 104

EN - 45
SELECTING ADDITIONAL FUNCTIONS
An additional function can be added to the main washing programme before pressing the Start button.
Select a programme and then press the function button to add one or more desired additional function(s).
Defautlt temperature
and programme
Default spinning
rate in rpm
Delay Pre-wash Extra rinse Extra Wash
40° Cotton 1400
40° Synthetic 1200
40° Mix 800
20° Delicate 1000
40° Sportswear 800
60° Allergy 800
60° Jeans 1000
40° Fine wash 800
15 Min. Short 15° 800
40° Intensive 800
ECO 40-60 1400
40° Wool 600
40° Bed linen 1000
Spin only 1000
Rinse & spin 1000
i
• For the maximum spinning rate, programme time, and other details of the ECO 40-60 programme, and other details of
the ECO 40-60 programme, please refer to the content on the Product Fiche page.
• The table shows which cycle offers which options for adjustment.
• Adding an additional function will prolong the programme time.
• Keep pressing the function button to make the desired selection of additional functions.
Manual interruption
To stop and cancel a washing programme, press the START PAUSE button and hold it for 3 seconds. Select the programme
SPIN & DRAIN and press the START PAUSE button. The appliance will run the programme and at the end of the programme,
the appliance pumps the water out of the drum. When the water is pumped out, the door will be unlocked.
PAUSE button
The washing programme can always be stopped by pressing the START PAUSE button. The washing programme is temporarily
paused when the time remaining until programme completion is flashing on the display unit.
If there is no water in the drum and water temperature is not too high, then the door will unlock after a certain period of time,
and they can be opened. To resume the washing program, first close the door and then press the START PAUSE button.
ERRORS
In case of an error or fault, the programme will be interrupted. An acoustic signal will warn about such occurrence and the error
will be flashing on the display [ E:XX ]. See the TROUBLESHOOTING TABLE for more information.
Power supply failure
The washing programme can always be stopped by pressing the START PAUSE button. The washing programme is temporarily
paused when the time remaining until programme completion is flashing on the display unit.
If there is no water in the drum and water temperature is not too high, then the door will unlock after a certain period of time,
and they can be opened. To resume the washing program, first close the door and then press the START PAUSE button.