35
FULLY AUTOMATED WATER TREATMENT PLANT FOR YACHTS AND HOUSEBOATS
aquonic | User Manual
aquonic
requires a solid horizontal base that can sup-
port 30kg for installation. Composite or plywood pa-
nels can be successfully used but need to be protected
from wetness. The plant must be screwed on the pa-
nels to prevent movement while reeling?. The plant’s
pumps cause noise, so
aquonic
should not be installed
below bunks that are used during daytime.
We deliver a separate prepump by default – the maximum distance
between inlet and plant is 3m in height and 5m in length.
Please state your desired cable lengths between plant and remote
control, hose lengths and the used supply voltage on board upon
ordering.
Use sufficiently large cables (double insulated rubber cable) with adequa
-
te protection for on board power supply. The cross section needs to be
at least 4 mm² for a 12 volt supply system on board or 2.5 mm² for a 24V
system respectively. The plant should be connected to a buffer batterie
instead of directly to the DC supply system because of the inrush currents
of the pumps. Please request adequate configurations
beforehand
, if you
do not use a 12 or 24V supply system on board. We deliver the appropriate
power supply on demand.
The assembly site should be easily accessible for
maintenance and allow assembling the plant in
one piece.
aquonic requires the following connections for operation:
• Inlet:
16 mm inside diameter, spiral reinforced hose
• Flushing water:
3/8“ (9,5 mm) Fresh water line from the vessel’s water supply
• Drainage:
3/8“ (9,5 mm) Fresh water line offboard or collection tank
• Tank connections:
3/8“ (9,5 mm) Fresh water line to the tank
• Supply voltage:
The plants requires 12 V with a 20 Ampere fuse (delay) or 24
• Volt with 10 Ampere Fuse respectively.
Summary of Contents for aquonic
Page 3: ...Benutzer Handbuch Version 2 0 Manual version 2 0 Manuel version 2 0 tom logisch...
Page 29: ...27...
Page 47: ...45...
