8
The machine will
not start
Fluctuating pressure
The machine
stops
Fuse blown
Pulsing machine
The machine turns
on and off by itself
The machine is on
but no water
comes out
The machine is not plugged-in
Faulty receptacle
The fuse has blown
Faulty extension cable
The pump is drawing in air
Valves dirty, worn or sticking
The water supply is not sufficient
Pump seals worn
The fuse has blown
Incorrect mains voltage
Thermal sensor activated
Partially blocked jet
Fuse too small
Increase in the amperage
Air in inlet hose / pump
Inadequate supply of water generated
Partially blocked jet
Water filter blocked
Folded pipe
Pump fuse and/or trigger out of order
No water supply
Water filter blocked
Blocked jet
Clean the filter
Clean the jet with a needle and by spraying
water rearwardly through the jet
Contact your nearest service centre
Connect the inflow water.
Allow machine to run with open trigger until
regular working pressure resumes.
Increase water pressure, check for blockages
and / or change the large pipe.
Clean the jet with a needle and by spraying
water rearwardly through the jet
Clean the filter
Unfold the pipe
Replace it with a fuse with higher amp
consumption than the washer.
Try without the extension cable
Replace the fuse
Unplug other appliances
Check that the mains voltage corresponds to the
specifications on the nameplate
Leave the machine to cool for 5 mins
Clean the jet with a needle and by spraying water
rearwardly through the jet
Check that hoses and connections are airtight.
Contact your service centre
Increase water pressure, check for blockages and
/ or change the large pipe.
Contact your nearest service centre
Plug the machine in
Try another receptacle
Replace the fuse Unplug other
appliances
Try without the extension cable
Summary of Contents for Force Xpress 79575
