_
Doc# 16302
Press Pilot 150 Manual
Page 78
- 5. Cont. Delay: this is the time the unit will delay
engaging the clutch (in continuous mode), once it has
received the “Initiate Auto Stroke” input. This timer is in
seconds and has a max of 30 seconds. Setting this to
zero will bypass the timer.
Continuous-On-Demand Functionality notes:
- If 1
st
stroke requires palm buttons is selected and the
“Initiate Auto Stroke” input is off, the palm buttons will
only allow you to complete one stroke. If the “Initiate
Auto Stroke” input is on, the press will continue to run
until the “Initiate Auto Stroke” input is turned off.
- If at any point in the stroke the “Initiate Auto Stroke”
input is turned off, the press will top stop and remain
armed. If the “Initiate Auto Stroke” input is again turned
on, the clutch will engage.
- Any of the following will disarm the unit:
i. Emergency Stop Open
ii. Immediate Stop Open
iii. Top Stop Open
iv. Any Mode change
v. PP150 Reset Button Pushed
vi. Tie Down Fault (Only if 1
st
stk req. pb…once
through bottom, this fault is bypassed)
vii. Any Latched Fault in the PP150
viii. The arm timeout timer is completed (only if the
clutch is off and timeout is enabled)
NOTE: Auto Single and continuous on Demand require full press
guarding by end customer. Toledo Integrated Systems is not
responsible for incorrect wiring or insufficient guarding while using
either of these two auto features.
16 Hydraulic Overload Monitoring
input
The PP150 is equipped with one input [tb 39] to monitor a
Hydraulic Overload Limit Switch. This input can be configured
to trigger a hydraulic overload fault either when it goes low,
or when it goes hi. Refer to the sample screen shot in
(Fig. 16.1). when the “input fault hi” has a checkmark, the
unit will declare a hydraulic overload fault when the input
goes high.
OUTPUT
There is one relay (Dry Contact) output [tb 72 &73] to
control the Hydraulic OL “Pump/Reset/Hold” solenoid. This
output can also be configured to be low or hi. When the
“output hi” has a checkmark, the output will remain on when
Summary of Contents for Press Pilot 150
