CardVisor Hardware Manual - Edge
Page 23 of 32
Installing Handheld into Bar Code Reader Cradle
1. Make sure the CardTool Magnetic Card reader is already installed in the
expansion slot of the Handspring Visor PDA
.
2. Align the slots on the side of the handheld with the raised rails on the bar code
reader cradle (see step 1 in figure below)
3. Insert raised rails into slots on side of handheld (step 3 in figure below) and
slide handheld towards front.
4. Slide handheld along rails until raised tab (see step 3 in figure below) on bar
code reader is visible. Then slide base of CardTool reader below raised tab.
5. Reconnect Power Connector (see step 4 in figure below).
