INSTALLATION
24
5
z
Do not charge the battery when the elec-
trolyte level is low. Otherwise, the bat-
ter y will be damage d and may cause
malfunction.
ENOW00014-0
z
Make sure that the battery leads do not
get stuck between the outboard motor
and boat when turning, etc.
z
The starter motor may fail to operate if
the leads are incorrectly connected.
z
Be sure to correctly connect the (+) and
(—) leads. If not, the charging system will
be damaged.
z
Do not disconnect the battery leads from
battery while the engine is operating, the
electrical parts could be damaged.
z
Always use a fully charged battery.
ENOW00015-0
Do not use a batter y that is not recom-
mended. Use of a battery not recommended
can lead to poor performance of, and/or
damage to, the electrical system.
ENON00006-A
Note
Recommended battery: 12V 40Ah/5HR,
350 (Cold Cranking Amps (CCA), In case of
cold whether: 12V70Ah/5HR (650CCA))
Specifications and features of batteries
vary among the manufacturers. Consult
the manufacturer for details.
* The battery should be purchased sepa-
rately and is not supplied with the out-
board motor.
1. Place the battery box in a convenient
position away from possible water
spray. Securely fasten both the box
and the battery so they do not shake
loose.
2. Connect the positive lead (+) to the
positive terminal (+) of the battery,
and then connect the negative lead
(—). When disconnecting the battery
always remove the negative lead (—)
first. After connecting the positive
terminal (+), securely place a cap on it
to prevent short circuits.
1.
Battery cord (red)
2.
Battery cord (black)
CAUTION
CAUTION
2
1
ENOF00022-0
Summary of Contents for MFS 15E EF
Page 1: ...O W N E R S M A N U A L MFS 15E Original instructions MFS 9 9E MFS 20E OB No 003 11144 2AH1...
Page 6: ......
Page 8: ...11 TROUBLESHOOTING 77 12 ACCESSORIES KIT 79 13 PROPELLER TABLE 80...
Page 17: ...17 4 LABEL LOCATIONS ENOM00019 A Warning label locations 1 2 8 7 5 6 3 4 ENOF01204 4...
