TocomSat Duo HD DVB-S2 HD, User Manual, Page: 32 / 32

There are two ways to program the remote control ; Automatic Code Search or Direct Entry
RCU Information RCU Information
31
Programing The Remote Control
1. Turn on the component you want to control (TV, VCR or DVD)
2. Press and hold the component key you want to program.
Holding the component key until the LED on the remote control turns on, then release the
key.
3. Point the remote at the component, press and release the UP (▲) button, then wait three
seconds or until the LED stops flashing.
At this point the remote control is searching for the correct code to program. If, after three
seconds, the component you want to control does not turn off, press and release UP (▲)
button again to tell the remote to search the next set of codes.
4. If the component you want to control does turn off; Press and release OK button , then
the LED blinks three times.
Using Automatic Code Search
1. Turn on the component you want to control (TV, VCR or DVD)
2. Locate the enclosed Code List. Find your brand of the component you want to control.
3. Press and hold the component key you want to program. Holding the component key until
the LED on the remote control turns on, then release the key.
4. Enter 3-digit code from the code list, then the LED blinks three times.
5. If you get no response, repeat these steps using the next code listed for your brand until
the component responds to the remote control command.
Using Direct Entry Method
Locking the volume controls to a single device makes it easier to control volume, without
having to guess whether the volume will change. If you lock the remote's volume controls to
the TV , you will always be able to change the volume to the level you want, without having
to adjust it on multiple devices.
If you want to lock the volume for the STB component ;
1. Press and hold the STB component key until the LED on the remote control turns on.
2. Enter 3-digit code, 9 9 9 .
3. Press and release the STB component key, then the LED blinks three times.
Unlocking volume control ;
If you want to unlock the volume for the STB component ;
1. Press and hold the STB component key until the LED on the remote control turns on.
2. Enter 3-digit code, 9 9 9 .
3. Press and release the STB component key, then the LED blinks three times.
Changing Volume Lock