SUNPAK LIMITED LIFETIME WARRANTY
This SUNPAK product has been carefully manufactured,
accurately adjusted, inspected and thoroughly tested before
shipment to assure you of the highest quality.
Should this SUNPAK product require service, we will repair
or replace, at our option, any part or the product itself, which
our examination shows to be defective in material or
workmanship. This warranty does not apply to wear and
tear associated with the normal use of the product. This
warranty is non-transferable.
Repairs will be made to the product at no charge, under the
terms of the warranty as stated above, only when
accompanied by a dated and itemized bill of sale and
nominal handling charge.
Be certain to follow all assembly and/or operating
instructions with this product. This warranty is not valid if the
product has been misused or damaged in any way that is
beyond our control or through normal wear and tear
associated with use. This warranty applies only to the
product and we are not responsible in any way for losses,
damages or any inconvenience caused by equipment failure.
Some states do not allow the exclusion or limitation of
consequential damages, so the above limitation or exclusion
may not apply to you. This warranty gives you specific legal
rights and you may have other rights which may vary from
state to state.
Should service be required, the product should be carefully
packed (in the original packaging if possible ) and sent,
prepaid and insured, along with a check or money order for
$9.95 (shipping and handling), to the address listed below. A
note briefly describing the nature of the defect should also
be enclosed to expedite handling.
Proof of purchase and payment for shipping and handling
must be included for warranty repairs.
Operating Instructions
Congratulations on the purchase of your new
SUNPAK tripod. Your tripod has been designed
to be a sturdy, rugged, and dependable product and
will provide you with many years of reliable service.
Please spend a few moments reviewing these
instructions, so that you can take full advantage
of your tripod’s features and capabilities.
Precautions
· Insure that all levers, handles, knobs and leg
locks are properly tightened, and that all three
legs are fully angled opened before use.
· Do not mount any camera directly onto the head
mount screw located on the bottom of the
tripod’s center column. The screw may be longer
than the tripod socket in your camera, and could
possibly cause damage.
· Do not carry or transport the tripod with the
camera equipment attached (as example but not
limited to: over your shoulder or cradled in your
arms).
· Do not Oil or Grease any part of the tripod.
· Do not use any solvents or thinners to clean your
tripod. Use mild detergent and wipe dry with a
soft, lint-free cloth only.
· Do not store or expose your tripod to
excessive heat or cold or use close to any flame
or fire.
· Do not exceed the load limit for this product.
OWNER’S RECORD
Please complete this section and retain with your original bill
of sale for your records.
Model Number: QSX 9002DX
Purchae Date: _____________________________________
Dealer’s Name: ____________________________________
Address: _________________________________________
City: _____________________________________________
State: _____________ Zip Code: ______________________
ToCAD America Inc.
Sunpak Tripod Division
53 Green Pond Road
Rockaway, NJ 07866
973-627-9600
www.tocad.com
Retractable Leg Spikes
Your QSX 9002D tripod is equipped with
retractable leg spikes for extra stability on outdoor
surfaces. To use the leg spikes, turn each of the
heavy duty rubber leg tips in a clockwise direction
until they stop. To retract the leg spikes, turn the
rubber leg tips in a counterclockwise direction
until they stop.
Note: The leg spikes should only be used
outdoors and caution should be exercised when
handling the tripod with the spikes exposed.
