© by WilTec Wildanger Technik GmbH
Item 63449
Page 9
http://www.toboli.com
09 2022-1
Disconnecting the gas bottle
1.
Close the oven burner valve. Make sure that the oven has cooled down.
2.
Then close the gas bottle valve by turning it clockwise as far as possible.
3.
After that, disconnect the gas pressure regulator from the gas bottle valve by turning the quick-
coupling nut counter-clockwise.
4.
Re-place the protection cap onto the gas bottle valve when not using the bottle.
Tightness check
The gas connections of the device have been checked for tightness before packing and sending. At the
site of use, this check must be re-done. Check the connection before each use of the oven. If at any
time you smell gas, stop operating immediately and check the entire system for leaks.
Warning!
•
During the tightness check, smoking is forbidden!
•
Never check for tightness with an open flame!
•
Only carry out the leakage test outdoors and not near sources of ignition!
Fire and explosion hazard!
•
Carry out the leakage test very carefully Leaking spots remaining undetected can lead to fires
that are no longer controllable while the gas oven is in operation. Serious property damage and
serious injuries can result.
Preparation
•
Check that all packing material has been completely removed from the device.
•
Make a soap solution (a 1:1 mixture of washing-up liquid and water).
•
A spray bottle, a paintbrush, or a cloth will be required to apply the solution onto the fittings.
•
A leak detection spray can also be used for it.
Check
1.
Switch off the burner.
2.
Open the gas bottle valve by turning it counter-clockwise.
3.
Apply the soap solution on all hose connections. Bubbles forming at a connection spot indicate
a leak.
4.
If leaks are found, immediately close the gas bottle valve. Tighten the leaking connections.
5.
Re-open the gas and re-check the spot.
6.
If bubbles and leaking spots persist, re-close the gas supply and ask an expert.
Use
The burner has a 4-kW power.
Preparation
1.
Make sure that a tightness check of the oven and hose connections has been performed and
the oven placed correctly. Only operate the device when all connections have been checked
and no leaks detected.
2.
Remove remaining packing material.
3.
Obey the following instructions to ignite the burner.
Caution!
Keep your face and hands as far as possible from the device when igniting it. If you wish to ignite the
burner with a match, use the match-holder supplied.
