Toastie Woodburners ELDUR Installation And Operating Instructions Manual Download Page 9

 Ref: 14/ST/BF/1 

This appliance is 

NOT

 suitable for use in a shared flue.

This appliance should 

NEVER

 be operated with the doors open.

NEVE

R clean glass when the stove is hot. 

ALWAYS 

use stove glass cleaner, which is available

from DIY and stove retailers, only when the stove is cool.

DO NOT

 use an aerosol spray on or near the stove when it is alight.

DO NOT

 use liquid fuels in this appliance.

NEVER

 leave the stove unattended for long periods without first adjusting the controls to a safe

setting – careful air supply control should be exercised at all times.

DO NOT

 modify the appliance as it could result in damage to the appliance or injury to users.

IMPORTANT – DO NOT

 fit an extractor fan in the same room as this appliance.

IMPORTANT – A MINIMUM DISTANCE of 1500mm from combustible material.

FIRES CAN BE DANGEROUS

 

– Always use a fireguard in the presence of children, the elderly 

or the infirm.  

DO  NOT  OVERFIRE  –  it  is  possible  to  fire  the  stove  beyond  its  design  capacity,  this  could 
damage the stove, so watch for signs of overfiring – if any part of the stove starts to glow red, the 
fire  is  in  an  overfire  situation  and  the  controls  should  be  adjusted  to  immediately  prevent  the 
overfiring.  

WARNING – FUME EMISSION 

Properly installed and operated, this appliance will not emit fumes. Occasional fumes from de-ashing 
and refuelling may occur. Persistent fume emission must be stopped. 

If fume emission does persist, then the following immediate action should be taken: - 

1.

Open doors and windows to ventilate room

2.

Put the fire out, or safely dispose of the fuel from the appliance.

3.

Check for flue chimney blockage and clean it if required.

4.

Do not attempt to re-light the fire until the cause has been identified and corrected.

5.

If necessary seek professional assistance.

IN THE EVENT OF A CHIMNEY FIRE 

Raise the alarm to let others in the house know. 

Call the Fire Brigade 

Close all air controls. 

Place a fireguard or spark guard in front of the stove. 

Feel the chimney breast for sign of excessive heat. 

Move furniture and rugs away from the fireplace and remove any nearby ornaments. 

DO  NOT  endanger  yourself  or  any  other  person,  so  if  necessary  leave  the  house 
immediately after calling the Fire Brigade. 

MAINTENANCE 

Summary of Contents for ELDUR












Reviews: