21
[Bottom]
100
10
1
NOT USE
UNIT ID
ON
1
2
Note
The figure below shows the setting switch label.
Remove the cover on the bottom side of the unit to expose its setting switches.
8
10
9
11
9. Monitor volume control
Adjusts the output volume of the monitor speaker
and right-side headphone output.
10. Headphone jack
Connect headphones to this jack (mini-jack).
Connecting the headphone cuts off the output
from the monitor speaker. (Refer to the table
below.)
Model
Output signal
TS-912 Base language or Translation language
Note: Switchable by the Monitor selector
switch (11).
TS-812 Base language
Note
A headphone jack is located on both the left and
right side panels.
11. Monitor selector switch (TS-912 only)
Selects either Base Language or Translation
Language for the source to be output to the
monitor speaker and headphone.
8. Unit address number setting switch
Set the unit address number (001 – 192), taking
care to ensure that the same number is not
duplicated in the system.
If the number [000] is assigned to a unit, the user
of that unit cannot speak. However, the unit can
be used for monitoring.
Set a numeral for the ones place and tens place.
Set this switch to OFF to set the hundreds place
to “0” and to ON to set it to “1.”
Note
This number is factory-preset to [000].
[Right side]
