Toa SR-F1B Operating Instructions Manual Download

Page: 6 / 14

SR-F1B SPEAKER STAND

This speaker stand is manufactured by König&Meyer GmbH(K&M) of Germany for use with TOA's SR-F1B speaker.
The speaker stand consists of two main sections:

Stand: Model 213

Bracket: Model 19582

USAGE (Refer to Fig. 1.)

Extending the Stand Legs.

1 . Loosen the tripod clamp screw and extend the tripod legs by

sliding the clamp ring down the length of the stand until the leg
stays are horizontal, then retighten the screw.

Mounting the Speaker.

2 . Attach the stand bracket to the base of the speaker using the

supplied mounting screws and washers. (Fig. 2).

3 . After ensuring that the bracket clamp screw is loose and not

protruding into the interior of the bracket, carefully place the

speaker on the stand by sliding the bracket over the end of the
stand.

4 . After positioning the speaker, tighten the bracket clamp screw.

Adjusting Stand Height.

5 . Loosen the height lock screw.
6 . Loosen the handle clamp screw, then fold out the crank handle

and retighten the screw.

7 . While holding down the lock button, adjust the speaker's height by

turning the crank handle. (Clockwise rotation raises the speaker.)

The handle cannot be turned without  holding down the lock button.
After  adjustment is completed,  release the lock button and make sure
that the shaft is securely locked.  (This can be checked by rotating the

handle slightly.)

8 . Retighten the height lock screw.
9 . Loosen the handle clamp screw, flip the handle back into its

foldaway position and retighten the handle clamp screw. Be sure
the handle is always folded up except when adjusting the height.

Removal After Use

10. After use, lower and detach the speaker, then collapse the stand

in the reverse order of the above procedure.

Speaker Mounting Screw Storage

After the stand bracket is detached from the speaker, the speaker

mounting screws can be inserted into the threaded holes of the stand
bracket for storage. (Fig. 3).

PRECAUTIONS

Only use the stand on flat,  hard ground or floor surfaces.
Avoid  installing the stand near narrow passages where passers by might trip over the tripod  legs.
When using the stand outdoors, take care to avoid  exposure to strong winds.
To reduce the chance of the stand toppling  over,  avoid  extending the stand too high.
When there is potential for instability and the danger of a fall,  be sure to secure the stand with guy wires or other
devices.

<Fig. 2>

<Fig. 1>

Speaker mounting screw

Plain washer

Threaded hole

<Fig. 3>

Plain washer-

Speaker mounting screw

Stand bracket
clamp screw

Height lock screw

Tripod clamp screw

Lock button