WARNING
Do not mount the Bracket Stay
directly to the plaster board using tapping screws. The
screws could slip from the board and the speaker could
fall off, resulting in personal injury.
533-06-068-50
5. SPEAKER MOUNTING
Step 1. Attach the Bracket Base to the speaker.
Step 2. Mount the Bracket Stay to the wall or ceiling.
• The Stay can be mounted to the wall or ceiling either
directly or by using an electrical box.
• Two different types of screws are supplied to mount the
Stay.
(1) 4x16 tapping screw (4 pieces)
Use this screw for mounting to the plywood board with
thickness of over 9 mm.
(2) M4x35 tapping screw (4 pieces)
Use this screw for mounting to the electrical box.
[Direct Stay mounting to the wall or ceiling panel]
In the following example, the distance between two
mounting holes in the Stay is 46 mm.
[Stay mounting by means of an electrical box]
2
-1
2
-5
2
-2
2
-3
2
-4
2
-4
2
1
M4x35 machine screw (standard accessory)
Approximately 3 mm
Double-gang
electrical box
Speaker cable
Bracket Stay
Wall panel
60 – 80 mm
Speaker
Bracket Base
M5x10 machine screw
(standard accessory)
M5 plain washer
(standard accessory)
2
-1
2
-5
2
-2
2
-3
2
-4
2
-4
1
2
4x16 tapping screws
(standard accessory)
Ceiling panel (9 mm or
more in thickness)
Speaker cable
Approximately
3 mm
Bracket Stay
Step 2-1. Temporarily install two of the supplied screws 46
mm apart, and leave them sticking out
approximately 3 mm from the wall or ceiling
surface.
46 mm
42 mm
Speaker cable outlet hole
Stay mounting position
The following figure shows the relationship of the speaker
cable outlet hole to the Stay mounting position.
Step 2-2. Pass the speaker cable through the cable outlet
hole in the Stay.
Using a cutter, you can easily make a
hole in a rubber plug put in the pipe end.
Tip: Mounting the Stay to the wall as shown above permits
the speaker to be freely mounted in any direction
indicated by the arrows.
If the cable is thin, it can be routed in the Stay pipe as shown
below.
Speaker
cable
Wall surface
Bracket Stay
Speaker cable
Step 2-3. Insert the Stay mounting holes onto the head of
screws temporarily installed in Step 2-1 (Arrow 1).
Step 2-4. Slide the Stay in the direction of Arrow 2, and
mount by means of the remaining two supplied
screws.
Step 2-5. Tighten the two screws temporarily installed in
Step 2-1.
Step 3. Mount the speaker with the Base attached in Step
1 to the Stay.
Step 3-1. Pass the Base through the Stay pipe, and
temporarily fix the speaker with the bolt.
Step 3-2. Connect the speaker cable to the speaker.
Step 3-3. Loosen the bolt used to temporarily fix the
speaker, and retighten it after determining the
speaker position.
WARNING
Do not install the Bracket Stay
as shown in the figure on the
right, as the speaker could fall
off, resulting in personal injury.
Up
Wall
Down
3
-2
3
-1
3
-3
Bolt
Wall
Speaker
Speaker cable
Note: Put the excess length of
cable back in the ceiling or wall
after connection completion.
