"Jumper Wire Setting"
M-01, 11, 21, 51, 61
All the microphone modules come with phantom powering capability. I
not desired, cut J1 on the board.
U-21
Cut J2 on the board to use as a remote master volume control unit
Leave J2 on to use as a remote-control AUX module.
U-61
Cut J2 on the board to use as a compressor unit which goes between
PREAMP OUT and POWER AMP IN (LINK IN/OUT).
M-11
Either (both) J3 or (and) J4 is (are) to be cut for a proper operation.
Refer to the table below.
^Z: Impedance Mute:
Normally "On", becomes "Off" when muting
__ terminals are closed.
Mute: Normally "Off", becomes "On" when muting
terminals are closed.
(Plug-in Modules)
S-01 (1 ,000Hz SINE WAVE)
CONNECTIONS
It is operated by closing the remote
switch.
Remote switch
S-02 (YELP AND BUZZER)
CONNECTIONS
Yelp signal
Remote switch
Buzzer signal
Each signal is generated by closing cor-
responding remote switches.
Remote switch
S-03 (ONE-TONE CHIME AND CONTINUOUS ONE-TONE
CHIME)
CONNECTIONS
One-tone chime
Remote switch
By closing the remote switch, chime
sounds once.
Continuous one-tone chime
Remote switch
By closing the remote switch, one-tone
chime sounds continuously during the
closure of the switch.
Rack-mounting Brackets Perforated Panel
(Silver) (Silver)
Volume Control Cover
J3
on
cut
on
cut
J4
on
on
cut
cut
Function
No output signal
Normally "Off", becomes "On" when muting
terminals are closed.
Normally "On", becomes "Off" when muting
terminals are closed.
Works as a regular microphone input module.
Plug-in Modules
Operation and Connections
Block Diagrams (Plug-in Modules)
Accessories
TOA 900 SERIES