3-1.
Direct mounting to a ceiling panel
Fold the supplied ceiling reinforcement ring in half*
and insert it trough the mounting hole in the ceiling
panel, then open it with its tabs facing up.
Place the ring on the ceiling panel aligning it with
the mounting hole.
The reinforcement ring is too large to be inserted
into the mounting hole unless folded.
Mounting hole
Ceiling reinforcement ring
(accessory)
Reinforcement ring placed on ceiling panel
These tabs must
face upward,
away from the hole
Step 4.
Attach a safety wire to prevent the speaker from accidentally falling.
Use the supplied ceiling reinforcement ring in conjunction with the optional HY-TB1 Tile Bar Bridge.
Refer to the instruction manual included with the HY-TB1 for the correct ceiling mounting procedure.
Note
HY-TB1 (optional)
Ceiling reinforcement ring (accessory)
Ceiling frame
Ceiling panel
Use the supplied ceiling reinforcement ring in
conjunction with the optional HY-AH1 Anchor
Hanging Bracket.
Note
Refer to the instruction manual included with the
HY-AH1 for the correct mounting procedure.
Anchor bolt
HY-AH1 (optional)
Ceiling panel
Ceiling
reinforcement ring
(accessory)
To attach, tie one end of the supplied
safety wire around the speker’s safety
wire hook, and tie its snap ring around a
secure C-channel bar or anchor bolt in
the ceiling.
Safety wire hook
Safety wire
(accessory)
Speaker unit
Secure C-channel bar or
anchor bolt in the ceiling
Loosen the cord clamp fixing screws and open the cord clamp.
Then, pass the speaker cable between both screws.
Speaker cable
Cord clamp
Clamp fixing screw (2 pieces)
Tighten the clamp fixing screw to
fix the speaker cable with the cord clamp.
Pull on the cable here to confirm that
speaker cable is securely fixed.
Detachable input connector
Speaker unit
Cord clamp
Detachable input
connector
Before mounting, check to be sure that the speaker’s 4
mounting tabs are turned inside the unit as shown in the
figure.
If turned outward, the speaker cannot be inserted
through the mounting hole.
Mounting tab
Out
In
Mounting hole
While doing so, avoid directly touching the speaker’s
surface.