Toa CP-63, Installation Handbook

Page: 50 / 59

PART 2. FUNCTION SELECTION FOR DATA
TRANSMITTING AND RECEIVING UNITS
9. SETTING OF CHANNEL SELECT SWITCH OF TRANSMITTING UNIT (DT-E11)
AND WORD SELECT SWITCH OF RECEIVING UNIT (DR-B61)
NOTE
1. Connect the DT-E11 and DR-B61 to Exchange correctly. (Refer
to operation manuals of DT-E11 and DR-B61).
2. Set the function select switches (DIP SWITCH) on CP-63 cor-
rectly and be sure to enter initial programming and function
registration at programming station No.200.
3. Remove the front panel of Data Transmitting Unit (DT-E11) and
take out the printed circuit board. Then set the channel select
switches located on the printed circuit board, according to the
necessary functions such as IN/OUT Annunciation, Calling Party
Indication etc,and replace in the Unit.
(Refer to 13. Explanation of Data Transmitting Unit Output
Data, Page 53).
4. The DT-E11 sends out 512 bit data (16 bit x 32 words) to
control relays on Data Receiving Unit (DR-B61). Therefore set
the two word select switches on DR-B61, according to necessary
output mode. SW-1 is for Relay No.1 to No.16 and SW-2 is for
Relay No.17 to No.32. See Page 51 for details.
(Refer to Explanation of Date Receiving Unit Output Channels.)
5. Connecting Cable YR-802 is used for the Rack mounting system.
Connecting Cable YR-806 is used for the Standard Cabinet
mounting system with only One (1) DT-E11 unit.
Connecting
Cable
YR-802
or YR-806
One Pair Cable
Connecting
Cable
YR-803
To other DR-B61
To other
DT-E11
CHANNEL SELECT
Switch (SW-1)
To other RD-B61
WORD SELECT Switch
(SW-1, SW-2)
— 49 —