7
6.2. Hanging Installation Procedure
6.2.1. Opening the cover
1. While holding the bottom of the camera housing base
①
with one hand, undo the cover latches
③
and
slowly lower the base to its full stop.
Note: Failure to hold the base when undoing the latches could result in the base falling suddenly and
possibly damaging the camera.
2. Move the sliding cover stays
⑧
outward until they click into their locking positions.
6.2.2. Closing the cover
1. While pressing the lock release buttons
⑦
individually, raise the camera housing base.
2. Secure the cover in place with the safety latches
③
.
7. CABLE ENTRY
1. Two cord entry bushings
⑪
and
⑫
are located at the bottom of the base
①
. Select either bushing that
matches with the cable diameter to use.
2. Remove the bushing cap first, and then a waterproof/dustproof rubber sheet from the bushing.
3. Run the cable through the bushing.
4. Turn the bushing cap to adjust the bushing diameter so that there is no gap between bushing and cable. If
the gap is created, wrap the self-adhesive butyl rubber tape round the cable entry area in order to prevent
raindrops from getting into the unit.
5. Ensure that the cable is secured by lightly pulling it.