TNT Rescue BFC-320, Operation Manual

Page: 15 / 30

TNT-OM # 7.2.3-041 Rev: 03-14-2016 15/30
Routine Maintenance Schedule:
Daily Inspection
Visually inspect all tools and components for damage, leaks and general cleanliness.
Inspect couplings; insure smooth operation, clean with silicone spray if necessary.
Check fluid levels in power unit:

Motor Oil

Hydraulic Oil

Fuel
Operate the power unit. Run engine and power at least one tool. Allow engine to run until
normal operating temperature is reached.
Add fuel if necessary.
Weekly or after use inspection
Visually inspect all tools and components for damage, leaks and general cleanliness.
Additionally:

Inspect cutter blades, look for debris in yoke area

Inspect spreaders for debris in yoke area.
Inspect couplings; insure smooth operation, clean with silicone spray if necessary.
Check fluid levels in power unit:

Motor Oil

Hydraulic Oil

Fuel
Operate the power unit. Run engine and power at least one tool. Allow engine to run until
normal operating temperature is reached.
Add fuel if necessary.
Monthly Inspection
Visually inspect all tools and components for damage, leaks and general cleanliness.
Additionally:

Inspect cutter blades, look for debris in yoke area

Inspect spreaders for debris in yoke area
Inspect couplings; insure smooth operation, clean with silicone spray if necessary.
Check fluid levels in power unit:

Motor Oil

Hydraulic Oil

Fuel
Operate the power unit. Run engine and power at least one tool. Allow engine to run until
normal operating temperature is reached.
Change fuel (for optimum performance never use fuel that is more than 30 days old).
Clean air filter
Clean spark plug, set gap (replace if necessary)- as per engine manual.
Annually Inspection
Have complete system serviced by an authorized / certified technician
Note: Appropriate Personal Protective Equipment should be worn while conducting the above
maintenance. Contact an authorized TNT Service Technician if any problems are found at any
time. An authorized TNT Certified Service Technician must perform annual service.