TNT Rescue BFC-320, Operation Manual

Page: 10 / 30

TNT-OM # 7.2.3-041 Rev: 03-14-2016 10/30
Tool Operation:
1) Once the power unit, rescue tool and hydraulic twin line hose have been
properly connected and the pump control valve engaged to the pressure
position, the tool is ready to operate.
2) Check the operation of the rescue tool by turning the control valve on the
tool to the open and closed position. Fully open and close the rescue tool
one to two times to purge any air from the system.
3) The Rescue tool is equipped with a dead man feature. When the valve is
released it will return to the neutral position and stop the operation of the
rescue tool.
4)
Once the use of the rescue tool is done or a tool change is needed, return
the control valve on the power unit to the neutral position
.(Note: TNT
hydraulic hoses and rescue tools are equipped with a pressure relieving
coupler, disconnecting hoses and or rescue tools with the control valve on
the power unit in the pressure position will cause hydraulic fluid to be
released to the environment.)
Rotate
Rotate
Open
Close