TMQ AP9 Autopilot (V6.0 - 965)
Page 11 of 51
31/1/2017
NOTE: Once the commercial watch alarm has been enabled, it cannot be
disabled by the user.
To enable the commercial watch timer alarm
·
When pilot is on press STANDBY button
·
Both standby and main lights will be on
·
Enter 906 via keypad
·
Display reads 906
·
Press and hold down STANDBY button
·
Press GOTO button
·
Display will read A-0
·
Standby light is off
·
Main light is flashing
·
Rotate large knob until display reads A-1
·
Press GOTO button
·
Display reads 000
·
Rotate large knob until display reads required time (eg: 005)
·
Press GOTO button to remember time set
·
Press MAIN button to exit commercial watch alarm mode
·
Main light will be on
·
Standby light will be on
·
Display reverts to course heading.
When the commercial timer is enabled and the autopilot is in control of the boat (i.e: in
AUTO, GPS
or
REMOTE AUTO
mode), the AP9 internal alarm sounds after
completion of the selected interval and the louder external alarm one minute later, unless
the timer is previously reset.
In
STANDBY, POWER
STEER
or remote
POWER
modes, the timer can be set to any
required time as for standard watch alarm.
Controls:-
Rate-of-Turn
This control sets the rate-of-turn for the vessel, to prevent very
sharp turns when changing course.
