•
Press the
< >
buttons simultaneously to set the Starboard Limit.
The number on the display will be between 0 and 31 to indicate the
rudder position. “SL31” being fully to Starboard and “PL31” being
fully to port.
If “ ---” (out of range) is displayed it indicates the rudder is not in the
correct position to set the rudder limit, eg:
Rudder is to port when
setting the Starboard limit.
If at any time during testing the motor runs under load and the rudder
does not move, checks should be carried out to confirm the limit
switches are operating prior to the rudder running into the stops.
Reset Rudder Limits
It is possible to reset the rudder limits to the factory settings if unsure
of the settings.
Press the MODE Button 7 Times
“ rLr” will Display (Reset Limit Rudder).
Press
< >
both simultaneously to reset rudder limit.
Compass Calibration
The compass is set to carry out an automatic compass calibration if the
vessel is turned through 360˚ within 4 minutes.
If the AP46 compass heading displays a
constant offset
when
compared to a correctly calibrated ships compass (eg: the autopilot
compass reads 3˚ high on all headings), simply rotate the AP46
compass sensor to align the displayed headings with the ships compass.
TMQ AP46 Autopilot
Page 18 of 34
Ver1.0 07/03/2007
