W W W . T M G I N D U S T R I A L . C O M P 1 4 / 1 9 T o l l F r e e : 1 - 8 7 7 - 7 6 1 - 2 8 1 9
Step 7 : Install front and rear cover panel
The door cover must be zipped. Use rope (#24) to lift up the front and rear
cover (#23) from the center grommet and tie it firm to the truss tube and
spread toward both sides through each grommet along the tube.
Insert the dropping tube (#15) into the bottom groove pocket on the door
cover. Tie two ropes (#20) separately on both sides of the peak arch tube. Pull
both ropes under through the bottom of the door cover from the back, then go
up from front and through both pulley (#11A and #11B) (Picture 9 & 10).
The rope coming out from pulley (#11B) must go through the upper wheel of
pully (#11A), then pull both ropes together slowly and start to lift the door
cover.
Tie both ropes to the corner baseplate. Now the door cover is up. When you
drop down the door cover, do not let go too quick, otherwise it might get stuck
and damage the fabric.
(Picture 9-view from inside)
