TMG TMG-HW28, Product Manual

Page: 12 / 41

OPERATING INSTRUCTIONS
1.Perform pre-start maintenance inspection on all applicable systems prior to operating the machine. This
is essential for the safe, effective and efficient operation. You will get optimum performance from your
system ONLY if these instructions and inspections are followed. Any indication that the pressure washing
system was not operated and maintained according to these instructions may cancel the manufacturers’
warranty.
Location – Be sure to install in an area that has sufficient air ventilation to support combustion of oil in
burner.
Controls – Make sure all controls turned to the off position.
Pump – Oil level - Level the pressure washer. Be sure oil level in the pump is correct on dip stick. If the
level is low, add the correct oil to the proper level. USE ONLY SAE 15 W-40 NON- DETERGENT OIL .
DO NOT OVER FILL.
Gas Engine - Gasoline level – The engine is a 4 cycle and uses regular octane, unleaded fuel. DO NOT
USE MIXED FUEL. Refer to the engine operation manual included with your pressure-washing unit.
Gas Engine - Oil level – The engine is a 4 cycle and uses 10W-30 detergent oil. Refer to Glossary or
engine manual.
Oil Fired Burner - Oil Tank Level – #2 Furnace oil is recommended for the burner oil tank, as it burns
cleaner and the burner requires less maintenance. Diesel fuel may be used as an alternative. Do not
overfill burner tank.
Visually inspect all electrical components to assure they are in good condition, showing No signs of
exposure, breakage or splicing.
Visually inspect all hoses, nozzles and guns to assure they are in good condition. If replacements are
necessary they must be rated to withstand the machines operating pressure and temperatures.
WWW.TMGINDUSTRIAL.COM P12/41 Toll Free:1-877-761-2819
10W-30
SAE30
5W-30