CHAPTER 2: Operation
Adjusting Volume
Press the + and - side buttons to adjust the volume. Press for 1 second to reach the
maximum or minimum volume level. (15 is the maximum).
Receive only Mode
Press the RCV button to switch to receive only mode. This mode only receives Laser,
and does not jam. Pressing the RCV button again will enable Auto sleep mode.
Adjustable jamming default is 4 seconds.
Auto/Quiet
Pressing one second enables Auto sleep mode, this stops jamming function after
selected Auto kill by the TMG Defender Lite App, Or a third party App. Auto sleep
mode will take 1 minute to relay back to 4 second jamming from RCV only mode.
Use caution for 1 minute because laser alerts will be muted until the CPU announces
“Auto sleep mode off”. Press the SLP/RPT button for 1 second to report police to the
server. ”Test mode” is recommended only for testing the jamming capability.
The RDT port is for radar detector integration, or other accessories. The side PWR
port can be used to power the unit with a 12v barrel connector 1.3 mm.
a-15
Power
Receive only
Algorithm update
For factory use only
System reset
Auto sleep/Report
Switches to determine heads 3 and 4 or rear.
TP (Terminal Ports 1-4 are connections for Transponders)
(Heads 1 and 2 are always front.)
Align pins on the transponder cable
with the connection port
AUTO/QUIET
RCV
UDT
RST
PWR TP1
TP2
TP3
RER
FRT
TP4
RDT
DTA
PWR
1 2
ON
Power port (1.35 mm)
TP4
RDT
8
9
CHAPTER 2: Operation cont.
Algorithm firmware Update - This firmware uploads the Lidar gun algorithms to the
CPU. (Must have strong Internet access) These updates
will come available as more Lidar gun firmwares are captured.
1. Connect to your Android or IOS device by the Starting the TMG Laser Defender
Lite App instructions mentioned above.
2. Once connected, push the UDT button on the CPU. An audio voice will say “Algo-
rithm update open app and select new algorithm and enable Bluetooth”
3. Press the Alglo update tab on the App, and you will hear an audio voice say “Start
transferring” select OK on the instruction screen.
4. The Alglo firmware will load up on top, by the loading bar, followed by the green
indicator light flashing on the app, and a blinking UDT CPU button.
5. The CPU will reset,and announce “Update finished or aborted returning to de-
fender mode” to confirm the upload.
CPU Control Firmware- This firmware uploads changes, or updates in the CPU only.
(This is not a common firmware to update)
1. Power on the TMG a-15 CPU, and pin the RST button on the side of the CPU for 2
seconds. A small red constant LED will appear on the CPU.
2. Open the TMG Defender Lite App and Connect to your device by Bluetooth.
3. Press the CTRL update tab on the App,and select OK.
4. “Start transferring” audio will announce.
5. The firmware will upload,followed by the small red LED flashing on the CPU,green
indicator flashing on the app
6. An Audio voice will announce “System On” with a power cycle to confirm the
update.
