Compact IP Codec User's Manual
57
Techno Mathematical Co., Ltd.
2140P
Appendix
1
. Errors and Warnings
Errors
Number
Log Output
Description
Required Action
LED Transition
E-001
E001:Parameter Error
Though incorrect
parameter settings are
normally not possible to
set on the setting screen,
an incorrect parameter
was discovered when
actual transmission
started.
The problem parameter
will be shown on the
display, so review the
settings of the applicable
parameter and its related
parameters.
The LED goes out when
the correct setting is
configured and the
output is started.
E-002
E002:FileWriteErr
Writing to built-in flash
memory failed.
If writing is not possible
after three retries,
contact TMC support.
At any point when
writing is not
successful for the first
three times, the LED
transitions as follows:
Lit 5 seconds -> Unlit.
E-003
E003:GBT Not Detect
Image port cannot be
detected.
Contact TMC Support.
LED lit only (does not
go out).
E-004
E004:Panel Con. ERR
Panel communication
error (remote screen and
log only)
Contact TMC Support.
LED lit only (does not
go out).
E-005
E005:AES Not Detect
AES devices not
connected to and AES
compatible device.
Connect the AES device
correctly.
Goes out upon AES
device connection.
E-100
E100:Connect Err
Could not connect to
encoder. (During user
authentication)
Check the password.
Check the connection
destination Tx IP
address, channel number,
etc.
Confirm that there are
fewer than 20 connection
destination Tx connected.
(On encoder)
Goes out upon
connection.
E-101
E101:Tx Discon
Disconnection of line
with the encoder.
Connect a different
encoder.
Change to the line
disconnection support
mode, and then connect
the line again.
In the case of a line
disconnection support
mode, connecting to the
set encoder will cause
error LED to go out and
the warning LED to
light. Warning LED
goes out upon
connection.
E-103
E103:Miss Encrypt Key
Could not obtain
encryption key.
LED lit for five seconds,
then goes out.