TMC BLUE BELLE CHIC/TO Instructions For Use Manual Download Page 7

 

The appliance should be positioned at no less than 1 m from other heat sources. 
Do not install the appliance in a room that already contains a gas cylinder (even if it is not in use) 
To lift or move the appliance from its intended position, use the dedicated handles. 
Never pull the gas hose to move the appliance. 
Do not move the appliance while it is operating.  
Do not move the stove while it is hot. 
Check for any damage: always check that the appliance is in good working order before using it. 

 

Respect the current local, regional and national regulations on gas. 
The appliance must be used in a dry, clean and ventilated room. 
The appliance should be used only in adequately ventilated rooms. To ensure ideal air ventilation, provide 
two openings of at least 25 cm

2

 per kW/h of heat (minimum opening 105 cm2 - 1/2 in high position and 1/2 

in low position in the room) 
The ventilation openings must be free as their purpose is to guarantee adequate ventilation, which ensures 
correct combustion. 
The front guard guarantees protection from burns that may be caused by accidental contact with the flame. 
IT DOES NOT CONSTITUTE FULL PROTECTION FOR SMALL CHILDREN AND DISABLED PEOPLE.  
Do not remove any part that make up the guard.  
Do not cover the stove using cloths, clothes or wet laundry that needs drying.  
Do not cover the stove as this would cause overheating. It is dangerous and therefore forbidden to position 
objects on the stove, as this would cause overheating. 
Do  not  position  the  stove  near  armchairs  or  curtains  (remember  to  take  into  consideration  that  curtains 
move) or other flammable material.  
Any object must be positioned at a minimum of: 
 

 

20 cm from the rear side of the stove 
50 cm from the sides of the stove 
100 cm from the front side of the stove 

The cylinder compartment can house cylinders of up to 15 kg. 
The stove should not be subjected to air current that exceeds 1.2 m/s.  

ATTENTION:

 Do not point fans directly toward the stove. Avoid air currents that may change the flame of 

the burner. 
When connecting the cylinder for the first time, and any time the cylinder needs to be replaced, ensure that 
the  room  is  well  ventilated  and  that  there  are  no  naked  flames.  Do  not  smoke  while  carrying  out  these 
operations.  
Do not remove or tamper with the regulator or with any other component of the stove.  
Protect the stove from the weather. 
Do not clean the stove with abrasive products.  
Do not put sharp tips and/or metal objects inside the appliance. 
Avoid improper use. The appliance should be used only and exclusively for the intended purpose. 
The  appliance  should  be  regularly  checked  for  wear  and  tear  signs  and  for  damages  by  qualified, 
authorized and trained technicians. Special care should be taken for hoses and connections. 
Use only and exclusively original spare parts.  For your safety, only use the spare parts expressly indicated 
in the user manual. 
Repair works must be carried out by a qualified technician. Have a qualified technician inspect the stove at 
least once a year. 
The  presence  of  excessive  dirt  caused  by  carpets,  animal  litter,  pet  hair,  etc.  may  require  more  frequent 
maintenance operations. 
Do  not  use  the  stove  if  it  has  been  immersed  in  water,  even  partially.  Contact  a  qualified  technician  to 
replace any part of the control system and any part of the gas system that were immersed in water. 
When igniting the stove after an extended period of inactivity, ensure that there are no foreign bodies inside 
it, such as dirt, insects, spider webs, and have the stove checked by a qualified technician. 
WARNING: do not use unapproved accessories. 
All  the  components  that  were  removed  to  carry  out  maintenance  operations  must  be  put  back  in  place 
before igniting the appliance. 
This heating  system should be used only and exclusively as indicated in this manual.  Any other use may 
cause fires, personal injuries and even death. 
To  turn  off  the  appliance  and  put  it  out  of  service,  close  the  gas  valve  on  the  cylinder  and  remove  the 
cylinder itself. 
 

Summary of Contents for BLUE BELLE CHIC/TO





















Reviews: