INSTALLATION
1. Install the feet in the holes on the underside of the pump body (see photo 1) and attach a
hosetail and hosetail O ring as required (see photo 2).
2. Install and secure the REEF-Pump controller in a suitable location where it can be easily
accessed and adjusted e.g. on the side or back of your aquarium cabinet, but ensuring it is
NOT mounted above the aquarium or sump, or in any position where it may accidentally
fall into water or be splashed by water.
3. Install the pump in your desired location e.g. sump, ensuring that it is fully submerged and
secured.
4. Connect the pump and the power supply unit (PSU) to the controller (see photo 3).
5. Connect the PSU to the mains electricity supply and switch on.
OPERATION OF THE DC CONTROLLER
Variable Speed Control
With 20 different speed settings to allow precise adjustment
of water flow and optimum performance.
When the REEF-Pump is switched on, the LCD screen on the
controller will display C01 (Constant Flow Mode – speed
setting 1). To increase the speed of the pump press “+” until
you reach the required level (maximum level will be displayed
on the LCD screen as C20 (Constant Flow Mode – speed
setting 20). To decrease speed press “
-
”.
Feed Mode
Press “FEED” to pause pump operation for 10 minutes.
When you enter FEED Mode the LCD screen on the
controller will display F10 (Feed Mode 10 minutes) and the
pump will stop pumping.
The controller will then start a 10 minute countdown which
will be displayed on the LCD screen of the controller, starting
at F10 and counting down in minutes to F09, F08 and so on
until it displays F00, at which point the 10 minutes have
elapsed and the pump will resume operation and start
pumping.
If you wish to restart the pump before the end of the 10 minute pause, press FEED again and
the pump will restart.
3
Photo 1
Photo 2
Photo 3
