5
OPERATION
Once mounted above the aquarium according to
one of the recommended installation methods
detailed above, the lamp unit may be connected to
the power supply unit (PSU) and then the PSU
connected to the mains using the power cord
supplied, and switched on. The lamp unit must not
be connected to, or used with, any PSU other than
that supplied by Tropical Marine Centre.
The PSU may be connected to the mains via a
suitable 24 hour timer device (not supplied) to
regulate when the lamp unit is switched on or off.
The in-line rocker switch enables switching of the
unit from all LEDs on, to only blue on, and then all
LEDs off. This enables a manually selectable
daylight/moonlight. This switch can be mounted to a
surface with the fixings supplied.The PSU may also
be connected to an AquaRay Control unit (available
separately) to simulate sunrise, sunset and
moonlight.
Caution:
Do not attempt to control or regulate in any
way the DC supply from the PSU to the MiniLED 500
lamp unit. Any attempt to do so may invalidate the 5
year guarantee on your MiniLED 500 lamp unit.
MAINTENANCE
Caution:
To avoid possible electric shock,
special care should be taken when using this
electrical appliance near water.
Caution:
Always isolate the PSU from mains
electricity before installing or carrying out any
maintenance to the lamp unit.
Caution:
Do not attempt to open the plastic case
of the PSU. This will invalidate the 1 year guarantee
on the PSU.
Caution:
Do not attempt to open the plastic casing
of your MiniLED 500 lamp unit. This will damage the
waterproof sealing and invalidate the 5 year
guarantee on the lamp unit.
The MiniLED 500 lamp unit and associated power
supply unit (PSU) is a sealed unit and is not a
customer serviceable part. The lamp array inside the
lamp unit is also not a customer serviceable part and
the whole lamp unit is to be disposed of at the end
of its life (>50,000 hours).