MACHINE SAFETY
To ensure that work is carried out in the best safety conditions, proceed as follows:
1.
.
2. For electrical versions, disconnect the plug (3) of the power cable from the mains supply socket (
).
CAUTION:
We recommend handling the power cable with dry hands to avoid serious injury.
CAUTION:
To prevent damaging the power cable, disconnect the plug from the mains socket by directly pulling the plug and not the
cable.
3. Check that the sanitizing solution tank is empty, otherwise empty it.
ATTENTION:
It is recommended to wear the appropriate PPE (Personal Protective Equipment), suitable for the work to be carried out.
ATTENTION:
the place designated for this operation must comply with current environmental protection regulations.
4. Engage the front wheel stops (1) (
).
TYPE OF BATTERY TO BE USED (battery-powered versions)
Used batteries must meet the requirements set out in DIN EN 50272-3 "Traction batteries for industrial trucks".
.
We advise using two 12V 33Ah
C5
AGM batteries to power the machine, as seen here to the side.
We advise using two 12V 33Ah
C5
AGM batteries.
BATTERY MAINTENANCE AND DISPOSAL (battery-powered versions)
For battery maintenance and recharging, respect the instructions provided by the battery manufacturer. When the batteries reach the end of
their service life, they must be disconnected by a specialized and properly trained operator, and must be subsequently removed from the battery
compartment using suitable lifting devices.
INSERTING THE BATTERIES INTO THE MACHINE (battery-powered versions)
The batteries must be housed in the special compartment inside the machine and should be handled using lifting equipment that is suitable both
regard to the weight and the coupling system used.
ATTENTION:
It is recommended to wear the appropriate PPE (Personal Protective Equipment), suitable for the work to be carried out.
ATTENTION:
to prevent an accidental short circuit use insulated tools to connect the batteries, and do not place or drop metal objects on
the battery. Remove rings, watches and any clothing with metal parts that may come into contact with the battery terminals.
HOW TO MOVE THE MACHINE
To transport the machine safely, proceed as follows:
DANGER:
before starting any task, make sure the current regulations concerning the safe transport of dangerous substances are
scrupulously observed.
1. Check that the sanitizing solution tank is empty, otherwise empty it.
ATTENTION:
It is recommended to wear the appropriate PPE (Personal Protective Equipment), suitable for the work to be carried out.
ATTENTION:
the place designated for this operation must comply with current environmental protection regulations.
2. Stand at the back of the machine.
3. Use a ramp to move the machine up onto the transport vehicle.
ATTENTION:
during this operation, check there are no people or objects near the machine.
the ramp gradient must not be such as to cause damage to the machine as it goes up.
4. Place the machine on the means of transport, and engage the front wheel stops (
).
WARNING:
Secure the device according to the directives in force in the country of use, so that it cannot slide or tip over.
16
