TMB Solaris Flare Q+ Rayzr 102, Operation Manual

Page: 6 / 32

6
Setup
Fuse Replacement
1. Flare Q+ Rayzr devices use a slow-blow fuse (5x20mm).
•
Flare Q+ Rayzr 50 uses a 2A 250V fuse
•
Flare Q+ Rayzr 100 uses a 4A 250V fuse
To replace a Fuse:
2. With a screwdriver turn the fuse cap counter-clockwise to remove fuse cap with fuse.
3. Replace fuse attached to fuse cap.
4. Reinsert fuse cap with new fuse and tighten clockwise.
Power Linking
Solaris Flare Q+ Rayzr has Neutrik
®
PowerCon IN and THRU connections allowing power linking (daisy-chaining).
Depending on the power provided, you should not exceed the power threshold.
Max. 5 units 100-120V; max. 10 units 208-240V for Flare Q+ Rayzr 50cm.
Max. 3 units 100-120V; max. 6 units 208-240V for Flare Q+ Rayzr 100cm.
Fixture Linking
A DMX data link is needed to operate one or more fixtures via a DMX-512 lighting console. The combined number
of channels required by all the fixtures on a DMX data link determines the number of fixtures the DMX data link
can support.
Important: Fixtures on a DMX data link must be daisy-chained in one single line. To comply with the EIA-
485 standard, no more than 32 devices should be connected on one data link. Connecting more than 32
fixtures on one serial data link without the use of a DMX optically-isolated splitter may result in
deterioration of the digital DMX signal.
Maximum recommended DMX data link distance between fixtures: 984 ft. (300 meters).
Disconnect the power cord before replacing the
fuse. Always replace with the correct fuse type.