TMB Solaris Flare Q+ Rayzr 102, Operation Manual

Page: 29 / 32

29
Config
Configuration setup. In this menu the following functions may be selected
Thermometer – Internal temperature gauge:
The built-in thermometer tracks internal operating temperature. Pressing the <UP> and <DOWN> buttons
selects degrees Celsius or Fahrenheit.
Fan Speed – Cooling Fan:
OFF- Cooling Fan is switched off.
SILENT- Reduced power and fan noise.
AUTO – Fan speed is automatically controlled by the Flare and will adjust according to temperatures at
normal operating levels.
FAST – Full Power, full fans when needed
Smart Fade – The Flare will attempt to add smoothness to crossfading DMX values coming from the lighting
controller but will also allow for very quick change of values where smoothness is not applicable.
ON- Smart Fade is turned On
OFF- Smart Fade is turned Off
Gamma Curve – Gamma correction curve selection. This sets direct relation between AC current to the LEDs
and the DMX value. The lower the value, the dimming curve and steps of intensity will be more noticeable at
the bottom of the DMX range. The higher the value, the smoother the bottom end of the curve will be where the
human eye detects more subtle changes.
Unit info - This selection shows devices software version and release date, as well as useful real-time
information, such as fan speed and temperature of the fixture, driver version, errors and temperature on each
chip.
Reset – Set factory defaults. Two options: NO and YES . Use the <UP> and <DOWN> buttons to change these
values.