TMB DATAPLEX DPNODE663PTB, User Manual

Page: 16 / 28

DATAPLEX DEVICES—Node 1x6 User Manual v1.1—25112020
16
STATUS
The default page of the Browser Interface is the STATUS page. This shows an overview of all the current settings
including node name, network settings such as IP and MAC addresses, port routing information for each of the 6
DMX ports, protocol settings and current firmware version. The STATUS screen is intended to show all the
pertinent operation information of the node at-a-glance and is un-editable.
NODE SETUP
The main setup page to configure the Node IP information as well as the Node Name. All settings changed in this
page are only applied after selecting the SET button at the bottom right of the screen.
NODE NAME
—
Change the name of the node to a desired name. The value in this field is directly editable and
can be used to differentiate Nodes by area or placement (e.g., Truss 1, FOH 2 or Server Room East).
IP ADDRESS
—
Change the IP Address to a desired address. The value in this field is directly editable. Note: IQs
that require a firmware update must be in the same subnet as ProPlex Software.
MASK
—
Commonly referred to as Subnet Mask. The value in this field is directly editable. Note: When EASY IP is
ON, Mask changes are unavailable.
EASY IP
—
When EASY IP is set to ON, the Node 1x6 will automatically find Art-Net and sACN traffic by searching
all masks, instead of just the current IP range. EASY IP is enabled with a dropdown menu.
LED BRIGHTNESS
—
Control the brightness of status LEDs at three levels: Off, Dimmed and Full. LED
BRIGHTNESS settings are enabled with a dropdown menu.