TM Induction Heating SURETHERM 10X, User Manual

Page: 14 / 36

TM INDUCTION HEATING 14 ST 2.0 |
`
Always use the magnetic temperature probe (hereafter referred to as
the ‘probe’) for heating in Temperature Mode or Ramp Mode.
` Place the probe on the workpiece, close to the bore. Make sure that
the surface used for the probe is free of grease and/or oil.
` If the induction heater has two probes: place one close to the bore
and the other on the outer ring.
`
Our standard probes are suitable for operation up to a maximum
temperature of 240°C (464°F). The connection between magnet and
probe will break above the maximum temperature. If this occurs
when operating in Temperature Mode, the heater will turn itself off as
the probe will fail to register any increase
in the temperature over a set period of
time. Probes for higher temperatures are
optional.
` Connect the probe by inserting the plug
into the socket at the front of the heater,
with the red dot facing upwards.
POSITIONING
THE MAGNETIC
TEMPERATURE
PROBE(S)
Treat the probe with care. It is a valuable part of the heater and can easily
be damaged through careless handling. After use, we suggest that it be
placed on the side of the vertical pole.
CAUTION