172-65637MA-05 (GP5C PowerTrap) 8 Jun 2020
21
1. Before Removing/Reattaching
Discharge the condensate from the body before removing parts.
(1 N
m
10 kg
cm
2
)
NOTE: If drawings or other special documentation were supplied for the product, any torque
given there takes precedence over values shown in this Instruction Manual.
2. Removing/Reattaching the Body from/to the Cover
Prepare a new, replacement cover gasket before beginning this step.
Cover Bolts
(M12
6 pcs)
• Using a 19 mm (
3
/
4
in
) socket wrench, loosen each bolt slowly
one turn in an alternating diagonal pattern.
• Once all bolts have been loosened, verify that there is no
internal pressure before completely removing the bolts.
• Reverse steps in
disassembly.
• Tighten to a torque of
60 N
m (44 lbf
ft).
Body
• When removing the body, lift the float and the float lever slightly
to avoid contact with the float.
• Reverse steps in
disassembly while
referring to the figure
below.
Cover
Gasket
• The gasket may be damaged or destroyed upon disassembly,
as it is inlaid in the body and may adhere to that groove; using a
scratch-free scraper, carefully scrape the gasket from the body.
• Replace with a new
gasket if damaged.
(1 N
m
10 kg
cm
2
)
NOTE: If drawings or other special documentation were supplied for the product, any torque
given there takes precedence over values shown in this Instruction Manual.
Cover Bolt
(M12)
Cover
Gasket
Float Lever
Body
Float
Cover
Part
Disassembly
Reassembly
Plug
• Using an adjustable wrench, slowly loosen the plug to release
pressure and discharge fluid, take care to avoid being burned by
fluid discharge.
• Wrap threads with
3
– 3.5 turns of sealing
tape or apply sealing
compound.
• Tighten to a torque of
30 N
m (22 lbf
ft).
Plug
Plug
